1: When installing two original R plates for docking and assembly or cutting one of them for docking and assembly, the part of the fiber mesh cloth extending from one of the plates needs to be stacked on the concave surface or surface of the other R plate, and then sealed with G3/WG3 adhesive.
2. If it is necessary to cut and use the R board according to the installation requirements, the clamp seam that can be connected when there is no extension net on both sides must be added with at least 120mm wide fiber mesh and sealed with G3/WG3 adhesive.
3. If it is necessary to cut and use the R board according to the installation requirements, when the R board without mesh extension is assembled with the R board or other walls, the connecting surface must be added with at least 200mm wide fiber mesh and sealed with G3/WG3 adhesive

1: When installing two original R plates for docking and assembly or cutting one of them for docking and assembly, the part of the fiber mesh cloth extending from one of the plates needs to be stacked on the concave surface or surface of the other R plate, and then sealed with G3/WG3 adhesive.
2. If it is necessary to cut and use the R board according to the installation requirements, the clamp seam that can be connected when there is no extension net on both sides must be added with at least 120mm wide fiber mesh and sealed with G3/WG3 adhesive.
3. If it is necessary to cut and use the R board according to the installation requirements, when the R board without mesh extension is assembled with the R board or other walls, the connecting surface must be added with at least 200mm wide fiber mesh and sealed with G3/WG3 adhesive

1: When installing two original R plates for docking and assembly or cutting one of them for docking and assembly, the part of the fiber mesh cloth extending from one of the plates needs to be stacked on the concave surface or surface of the other R plate, and then sealed with G3/WG3 adhesive.
2. If it is necessary to cut and use the R board according to the installation requirements, the clamp seam that can be connected when there is no extension net on both sides must be added with at least 120mm wide fiber mesh and sealed with G3/WG3 adhesive.
3. If it is necessary to cut and use the R board according to the installation requirements, when the R board without mesh extension is assembled with the R board or other walls, the connecting surface must be added with at least 200mm wide fiber mesh and sealed with G3/WG3 adhesive

1: When installing two original R plates for docking and assembly or cutting one of them for docking and assembly, the part of the fiber mesh cloth extending from one of the plates needs to be stacked on the concave surface or surface of the other R plate, and then sealed with G3/WG3 adhesive.
2. If it is necessary to cut and use the R board according to the installation requirements, the clamp seam that can be connected when there is no extension net on both sides must be added with at least 120mm wide fiber mesh and sealed with G3/WG3 adhesive.
3. If it is necessary to cut and use the R board according to the installation requirements, when the R board without mesh extension is assembled with the R board or other walls, the connecting surface must be added with at least 200mm wide fiber mesh and sealed with G3/WG3 adhesive